dnl	$OpenBSD: hardware,v 1.162 2015/10/18 07:09:44 jsg Exp $
OpenBSD/MACHINE OSREV runs on the following classes of machines:
	Ultra 1/1E
	Ultra 2
	Ultra 3 Mobile Workstation
	Ultra 5/10
	Ultra 25/45
	Ultra 30/60/80
	SPARCengineUltra AX
	SPARCengineUltra AXe
	SPARCengineUltra AXi
	SPARCengineUltra AXdp
	SPARCengineUltra AXmp
	SPARCengine CP1500
	Enterprise 150
	Enterprise 220R
	Enterprise 250
	Enterprise 420R
	Enterprise 450
	Enterprise 3000/4000/5000/6000
	Enterprise 3500/4500/5500/6500
	Enterprise 10000
	Sun Blade 100/150
	Sun Blade 1000/2000
	Sun Blade 1500/2500
	Sun Blade T6300
	Sun Blade T6320
	Sun Blade T6340
	Sun Fire V100/V120
	Sun Fire V125
	Sun Fire V210/V240/V440
	Sun Fire V215/V245/V445
	Sun Fire V250
	Sun Fire 280R
	Sun Fire V480/V880
	Sun Fire V490/V890
	Sun Fire V1280
	Sun Fire T1000/T2000
	Sun SPARC Enterprise T1000/T2000
	Sun SPARC Enterprise T5120/T5220  (see note below)
	Sun SPARC Enterprise T5140/T5240
	Sun SPARC Enterprise T5440
	Sun SPARC Enterprise M4000/M5000/M8000/M9000
	Sun SX1500
	Sun SX2500
	Sun SX3200
	Netra AX1105
	Netra AX2200
	Netra X1
	Netra 20/T4
	Netra 120
	Netra 210/240/440
	Netra 1280
	Netra 1290
	Netra T1 100/105
	Netra T1 AC200/DC200
	Netra T 1100
	Netra T 1120/1125
	Netra T 1400/1405
	Netra CP3060
	Netra CP3260
	Netra T2000
	Netra T5220
	Netra T5440
	Sun Fire E2900/E4900/E6900
dnl XXX uncomment machine entries as they become supported
dnl	Sun Fire 12K/15K
dnl	Sun Fire E20K/E25K
	Fujitsu PRIMEPOWER 1
	Fujitsu PRIMEPOWER 250/450
	Fujitsu PRIMEPOWER 650/850  (with SPARC64-V processors only)
	Fujitsu SPARC Enterprise T1000/T2000
	Fujitsu SPARC Enterprise T5120/T5220
	Fujitsu SPARC Enterprise T5140/T5240
	Fujitsu SPARC Enterprise T5440
	Fujitsu SPARC Enterprise M4000/M5000/M8000/M9000
as well on faithful clones of the above Sun systems, including:
	Momentum Leopard-V
	RDI/Tadpole UltraBook 170/200
	Tadpole SPARCLE 550SX/650SX
	Tadpole Viper
	Tadpole/Sun Voyager IIi

    Note: SPARC Enterprise T5120 and T5220 systems need at least OpenBoot
    4.28.0 to run OpenBSD.  Please refer to the ``Updating your firmware''
    section later for firmware update instructions.

Even if your machine is not listed above, it is possible that OpenBSD/MACHINE
will work on it.  OpenBSD/MACHINE does not work on machines with Fujitsu's
SPARC64-I, SPARC64-II, SPARC64-III and SPARC64-IV processors.

OpenBSD/MACHINE OSREV supports SMP (Symmetrical MultiProcessor)
systems.  To support SMP operation, a separate SMP kernel (bsd.mp) is
included with the installation file sets.

24MB of RAM should be sufficient to boot and a minimal system can probably
be squeezed onto a 250MB disk by installing only the `base' set.
However, a minimum of 32MB is recommended for serious usage of the system.